SPEEDYBEE STACK | F7 FC + 45 Amp ESC | Wireless Configuration

(No reviews yet) Write a Review
same day shipping
Calculated at Checkout
Adding to cart… The item has been added

SpeedyBee Stack is the world first wirelessly configurable stack! Tune it via Bluetooth by the SpeedyBee APP, flash it and check your BlackBox via WiFi! No need for any add-on dongles, just pair it with your smartphone!


This stack is not only this: it's equipped with cutting-edge components and it has been designed for top-notch performances!


The FC can count on:

  • F722 MCU
  • BMP280 barometer
  • the well known MPU6000 Gyro
  • support for both Betaflight and Emuflight
  • 9V 2A BEC

Ready for Digital FPV gears like DJI Air Unit or Caddx Vista and Nebula.

The ESC is a real modern art masterpiece!

  • 21 capacitors to let you enjoy noise free brutal accelerations
  • 811 holes tactically positioned for lightning fast current flow
  • real 45A (up to 50) continuous output tested with 1900Kv T-motor F80 and 51499 propeller

All this power can be easily controlled in palm of your hand by your smartphone. Any time, anywhere!

Icing on the cake: both the FC and ESC have a cutout on their edge for the back of the FPV camera and to allow the most compact built you can imagine!

SpeedyBee STACK. Try the difference!



  • Barometer: BMP280
  • IMU(Gyro):MPU6000
  • Bluetooth/Wifi Chip:
    • Bluetooth for firmware config.
    • Wifi for data transfer - firmware flashing and BlackBox analysis
  • 8P JST Connector to ESC
  • MCU: STM32F722
  • Flash: 16Mb for Blackbox
  • USB: Type C
  • OSD: AT7456E
  • BEC: 5V 2A + 9V 2A
  • 6P JST Connector to DJI FPV System
  • UART: 5 Sets
  • Firmware: Betaflight/Emuflight
  • Target: SpeedyBeeF7V2


  • Mosfet: NTMFS5C430NL x 14
  • Filtering Caps: 47uF x16
  • Amp-meter
  • Voltage: 3-6S
  • 8P JST Connector to FC
  • MCU: STM32F051 x4
  • Continuous Current: 45A x4
  • Burst 55A
  • Protocol: Dshot300/600/1200

What's in the box:

  • 1x SpeedyBee F7 V2 FC
  • 1x SpeedyBee 45A ESC
  • 1x 50V 470uF Capacitor
  • 1x XT60 Cable
  • 1x JST 8pin 30mm
  • 1x JST 8pin 15mm
  • 1x DJI 6pin 80mm
  • 5x M3*30 screws
  • 5x Nylon Nuts
  • 5x Grommets M3*8mm
  • 5x Grommets M3*6.6mm

Wiring instructions: