null

Zeez F7 3030 FC + 60A BLHeli32 Stack

SKU:
ZEEZ_3030_F7_60A
€109.90
(No reviews yet) Write a Review
Current Stock:

A good compact stack, designed with official FAI racing and pilot cpmfort in mind. 

An advise: just after received, connect the FC to the USB and calibrate the accelerometers BEFORE to start soldering.

Zeez F7 Specifications:

  • Mounting holes: 30×30
  • Up to 8S input (max 36V)
  • 5V BEC up to 3A continuous
  • STM32F722 MCU (Support BetaFlight, EmuFlight, INav)
  • MPU6000 Gyro/ACC for smooth performance
  • 128MB Onboard flash
  • OSD chip Onboard
  • 6 available UART
  • VTX switch to control the ON/OFF of the VTX directly from your transmitter
  • LC Filter for 5V VTX
  • USB Type C connector
  • Onboard RGB LED distribution for clean wiring to the LED on the arm of the quad.
  • Onboard RBG LED
  • Notch design on sides and in the front of the – FC for better fitting on the frame.
  • Direct solder connection and board space for TBS Nano RX and TBS Unify Pro32 Nano providing the ultimate in clean stack installation.
  • Logic Side and USB current protection


Zeez ESC 4in1 60A Specifications:

  • Mounting holes: 30×30
  • Input: 3S to 6S
  • High quality Mosfet: 60A continuous current draw /90A peak current
  • Aluminum HeatSink to cooldown the Mosfet.
  • BlHeli32 Firmware (support Dshot150/ Dhsot300 /Dshot600/ProShot 1000) and still compatible with all older analog protocol (OneShot42, OneShot125, Multishot)
  • 8 Pin JST connector and 8 Pin solder pads
  • Holes for Aluminum Low ESR capacitor (included 35V 470uF Low ESR capacitor and a spare capacitor)
  • Onboard analog current sensor (Firmware Scale: 350)
  • ESC telemetry to read RPM and ESC temperature
  • Compatible with Bidirectional Dshot out of the box



Zeez 3030 STACK (without LED) includes:
(1X) Zeez F7 Flight Controller
(1X) Zeez 60A 4in1 ESC
(8X) Aluminum Standoff
(4X) Aluminum Nut
(1X) ESC to Flight Controller 8 Pin to 8 Pin JST SH 1.00mm connector
(1X) ESC to Flight Controller 8 Pin to Free wires (with JST SH crimp) JST SH 1.00mm connector
(1X) ESC to Flight Controller 8 Pin to Servo Connector JST SH 1.00mm connector
(1X) JST SH 8 Pin Plastic Housing
(1X) JST SH 10 Pin Plastic Housing
(2X) 470uF 35V Low ESR Capacitor
(1X) XT60 with 12AWG Silicon Cable for battery connection
(2X) 2.00mm Header Pin for VTX connection
(2X) 2.54mm Header Pin for Receiver connection
(4X) Spare M3 rubber anti vibration for Flight Controller or ESC